If you need to use Safe Mode to remove or disable components, restart your computer, press F8 to select Advanced Startup Options, and then select Safe Mode. Disable BIOS memory options such as caching or shadowing. If problems continue, disable or remove any newly installed hardware or software. If this is a new installation, ask your hardware or software manufacturer for any Windows updates you might need. On some PC’s the error text may be a little different: A problem has been detect and Windows has been shut down to prevent damage to your computer.Ĭheck to make sure any new hardware or software is properly installed. Run CHKDSK /F to check for hard drive corruption, and then restart your computer. Check your hard drive to make sure it is properly configured and terminated. Remove any newly installed hard drives or hard drive controllers. If this screen appears again, follow these steps:Ĭheck for viruses on your computer. If this is the first time you've seen this Stop error screen, restart your computer. Here is an example of “0x0000007b” error screen for Windows XP, Vista and Windows 7:Ī problem has been detected and Windows has been shut down to prevent damage to your computer. However, if the PC suddenly loses access to the system partition during startup, then the “0x0000007b” error screen is displayed and the boot process is halted. Then, the bootsector code loads the bootloader, which is responsible for loading the operating system. When a computer is turned on, the BIOS picks an eligible, bootable hard drive and then calls code stored in the MBR at the start of that hard drive. That MBR code in turn loads the bootsector from the active partition. Symptom 1: “0x0000007b” error screen on startup The error messages, alerts, warnings, and symptoms below are tied to this error. The following information on this error has been compiled by NeoSmart Technologies, based on the information gathered and reported by our global network of engineers, developers, and technicians or partner organizations. 3.10 Fix #10: Repair the EFI bootloader.3.6 Fix #6: Replace NTLDR and NTDETECT.COM files.3.5 Fix #5: Check your disk with CHKDSK utility.3.4 Fix #4: Repair corrupted system files with the SFC command.

3.3 Fix #3: Boot into Last Known Good Configuration.3.2 Fix #2: Check drive for viruses with Easy Recovery Essentials.3.1 Fix #1: Rebuild boot files with Easy Recovery Essentials.2.2 Cause 2: Incorrect BIOS configuration.2.1 Cause 1: Bootloader files are missing or corrupt.1.2 Symptom 1: “0x0000007b” error screen on startup.

Windows 7 stop 0x0000007b virtualbox